JB Kind Interior Doors

Filter by price


Filter by Door Style

Filter by Doors Size

Product Categories

Showing 1–32 of 170 results

JB Kind Interior Doors

New to our catalogue of door ranges is the interior door collection from JB Kind. The range of doors is wide and full of variety and includes all the traditional styles as well as more contemporary styles sure to suit and home. The interior doors are available in pre-finished or unfinished oak veneers, solid timber doors with white primed finish, moulded panel doors ina variety of modern and traditional styles and JB Kind can also offer a bespoke service. Please contact us for details


JB Kind’s Installation and Storage Guidelines

Upon receipt of your new interior doors from JB Kind, please ensure that you check the doors carefully for their condition and suitablity for use in the home. Once you have checked the doors are in good condition please store the doors flat, fully supported off the floor with at least 3 bearers the full width of the doors equally spaced apart, in a dry well ventilated area. Where you have ordered un-finished doors, please ensure that all faces and edges are sealed before any commencement of installation is begun. We would recommend that you pay particular attention to the edges of the doors and use a quality solvent based finish that has recognised sealing properties.

NB. Danish oil, tung oil and Linseed oil are penetrating oils and must not be used on any interior doors, they do not offer any protection or seal to the door and do not avoid any moisture getting into the door.

If trimming of the door leaf is necessary please reduce the top and bottom edges equally – and not excessivley! If the width of the door needs to be trimmed, please trim the hinge side first and only if necessary then trim the meeting edge – again not too much trimming is advised – 5mm is probably a good guide. As a general rule you will require 3 hinges per door leaf – for internal doors 3 no. 75mm hinges are recommended. Please note that panel door mortises should not be located at any rail joints as this could significantly weaken the internal door structure.

Fire Doors should only be trimmed to the recommended limits and installed with the correct fire rated ironmongery – otherwise the doors will not meet the required certification.



By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.